Set up Assets Discovery

To run and set up Assets Discovery:

  1. Extract the Discovery package on the system where you will run the tool. 
  2. Start a command prompt and move to the extracted Discovery folder.
  3. Run the command prompt with Administrator privileges. 

    This will be required to write into the destination folder if you choose "C:\Program Files" or it will be needed to install the Discovery tool as a service.


初めに、利用可能なコマンドを「Discovery -?」で表示できます。



Without a start up parameter the Discovery tool will start a scan with all stored settings.
Discovery.exe -s
Open the Discovery tool settings.
Discovery.exe -r <ScanSettingID>
Run one configured setting.
discovery.exe -r <ScanSettingID>;<ScanSettingID>...
Run multiple settings. Separate their names with a semicolon.
discovery.exe -rs <IP-Address>
1 つのアドレスに対して手動スキャンを実行します。
discovery.exe -stsc
Check and run reached scheduled scan settings
discovery.exe -stad
Starts collecting data from available Discovery agents
Discovery.exe -v
Shows the version number of the Discovery tool
discovery.exe -l
ローカル システムのスキャンを開始します。ログオンしているユーザーの資格情報が使用されます
Discovery.exe -i
*Installing the Discovery tool as a Service
Discovery.exe -u 
*Uninstalling the Discovery tool Service
Discovery.exe -lu <Key>
Update the Discovery license via CLI
Discovery.exe -resetpassword
Reset your password, if you forgot it. (Important: Your encrypted credential-store will be deleted!)
Discovery.exe -z
構成した設定で結果データのパッケージ作成 (必要な場合) と転送を開始します

*Only available by using the Discovery tool on a Windows Environment.


Run "Discovery -s" to configure the Discovery tool Settings. Once you do, you will see scan settings divided into tabs. Check the following pages for details:

最終更新日: 2022 年 10 月 27 日


Powered by Confluence and Scroll Viewport.