clover-snapshot
説明
The <clover-snapshot> task generates a snapshot file used to assist Clover in optimizing the tests run in subsequent. This task should be run at the end of a build (i.e. after all unit tests have run).
パラメーター
属性 |
説明 |
必須 |
|---|---|---|
ファイル |
Specifies an alternative location for the snapshot file. |
No; defaults to the initstring + ".snapshot". |
span |
Clover interval (e.g. "2m" or "3h"); specifies, for the initial build cycle, the span for coverage used in generating the snapshot file used for test optimization; normally only specified when multiple interleaved compiles & test runs happen during a build cycle |
No; defaults to "0s" (zero seconds). |
例
<clover-snapshot/>
Generates a snapshot file used to assist Clover.
<clover-snapshot file="C:\My Documents\clover.snapshot"/>
Specifies an alternative location of "C:\My Documents\clover.snapshot" for the snapshot file.
<clover-snapshot span="3m"/>
Defines a custom span of "3m" (three minutes) used in generating the snapshot file used for Test Optimization.